Sale!

    Optimize Your Drone with Zeez F7 3030 V3 FC – Best for 2024

    $61.00

    The ZEEZ F7 V3 3030 is an 8 Motor Output, DJI HD System Ready Flight Controller with an on-board 9V@3A regulator to power the DJI Air Unit, with a simple plug-and-play configuration and 5V@3A regulator to power all the peripheral.
    Add to Wishlist
    Add to Wishlist

    Description

    About this product

    The ZEEZ F7 V3 3030 is an 8 Motor Output, DJI HD System Ready Flight Controller with an on-board 9V@3A regulator to power the DJI Air Unit, with a simple plug-and-play configuration and 5V@3A regulator to power all the peripheral.

    It uses a powerful F7 processor along with top-of-the-line hardware:  ICM42688P Gyro, BMP388 Barometer, with a separate power rail for cleanest data. The ZEEZ F7 V3 3030 comes in a standard 30×30 form factor. It comes with spaces and pads for TBS Crossfire and TBS Unify Nano32 for a very clean and low-profile assembly. Zeez have added a connector for a 2nd ESC to make building X8s as easy as possible. There are 5 UARTS available as well as an I2C port, SD CARD for Blackbox data record, and an OSD chip for analog video.

    Features

    •  8 Motor Output
    • Uses a powerful F7 processor along with top-of-the-line hardware
    • Comes with spaces and pads for TBS Crossfire and TBS Unify Nano32
    • 5 UARTS available
    • DJI HD System Read
    ZeezF73030 Optimize Your Drone with Zeez F7 3030 V3 FC - Best for 2024

    Specifications

    • Mounting holes: 30.5×30.5mm
    • LiPo Power input: 3S-6S
    • 8 Motor output
    • BEC 5V-3A / 9V-3A
    • STM32F722 MCU (216MHz max frequency)
    • ICM42688P Gyro/ACC
    • BMP388 Barometer
    • OSD chip Onboard
    • 5 available UARTs / I2C bus
    • SD Card Reader
    • HD Plug for DJI Air Unit or Caddx Vista or Walksnail VTX
    • USB Type C connector
    • Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation

    Includes

    • 1x Zeez RC F7 3030 Flight Controller V3
    • 4x Aluminum Standoff
    • 4x Aluminum Nut
    • 1x ESC to Flight Controller 8 Pin to 8 Pin JST SH 1mm Connector
    • 1x ESC to Flight Controller 8 Pin to Free Wires (with JST SH crimp)
    • 1x 2nd ESC to Flight Controller 5 Pin to 8 Pin JST SH 1mm connector
    • 1x 2nd ESC to Flight Controller 5 Pin to Free Wires (with JST SH crimp)
    • 1x JST SH 8 Pin Plastic Housing
    • 1x JST SH 10 Pin Plastic Housing
    • 2x 2.00mm Header Pin for VTX Connection
    • 2x 2.54mm Header Pin for Receiver Connection
    • 1x JST 6 pin to AirUnit Connector