Best BOB57 O3 Cinematic 6S HD 2024
The iFlight BOB57 is a long-range HD drone that was designed in collaboration with pilot & videographer Ellis van Jason. The team crafted this cinematic 6-inch drone that ensures agility and flight time while combining the advantages of both 5-inch and 7-inch drones for both cinematic and freestyle flights.
Hybrid motor design optimized for that can be used with both bi-blade and tri-blade 6″ propellers
High-end GPS is used to minimize the risk of failure during proximity flights
Long backbone with enough space up to fit 3000mAh 6S batteries
Solid antenna mount for less ocillations when using long antennas
Gladiator shell protects from dust and water droplets
ESCs with built-in spike absorber for more reliability
Built in BEC to directly power a GoPro camera
9-minute flight time with 3000mAh 6S Lipo
Product Name: BOB57 O3 6S HD BNF
FC: BLITZ F722
ESC: BLITZ E55 55A 4-IN-1 ESC
Video Transmission: DJI O3 Air Unit
Frame: 280mm wheelbase
Motor: XING2 2506 motors
Prop: GEMFAN 6032-3 propellers
Takeoff Weight: Approx. 580 g
Dimensions (L×W×H)：226×166×34 mm
Max Speed: 180 Km/h (Manual Mode)
Maximum Takeoff Altitude: 7000 m
Max Hover Time: Approx. 8 mins (With 6S 1400 no load.)
Max Wind Speed Resistance: Level 7
Operating Temperature Range: -10° to 40° C (14° to 104° F)
Antennas: 2 Antenna
Product Name: DJI O3 Air Unit
Weight: Approx. 36.4 grams（headband included）
Dimensions (L×W×H): L32.5 * W30.5 * H 14.5mm
Communication Bandwidth： Max 40 MHz
FOV (single screen): 155°
Communication Frequency: 2.400-2.4835 GHz；5.725-5.850 GHz
With DJI FPV Goggles V2:
810p/120fps Video Transmission Quality: The latency is lower than 28 ms.
810p/60fps Video Transmission Quality: The latency is lower than 40 ms.
With DJI Goggles 2:
1080p/100fps Video Transmission Quality: The latency is as low as 30 ms.
1080p/60fps Video Transmission Quality: The latency is as low as 40 ms.
Max Video Transmission Bitrate: 50 Mbps
Max Video Transmission Range：10 km (FCC), 2 km (CE), 6 km (SRRC)
Operating Temperature Range: -10º to 40º C (14° to 104° F)
Power Input: 7.4-26.4 V
Audio Transmission: N/A
1 x BOB57 6S HD BNF
2 x Antennas
2 x Battery pads
2 x Prop(Pairs)
Don’t worry about tuning, we did that for you already! A basic PID- and Filter tuning was applied for a great flight experience!
To restore lost tunes or updates, please check our linked article on “Firmware/Factory Dumps”
Angle-Mode (self balancing level mode) is enabled by default to make sure your first flight doesn’t end in a mess!
Please check our linked article on “How to disable Angle-Mode, activate Acro-Mode”
1. iFlight products may be used for civilian purposes only and any direct or indirect use of iFlight products for or in connection with the following is prohibited:
(1)Any military combat purpose or military combat related use;
(2)Terrorist activities: The purchaser also shall require its customers or end users to comply with the foregoing requirements.
2. If party A has violated applicable export control or economic sanctions laws and regulations, Party B has the right to immediately suspend delivery of products to Party A or terminate relevant cooperation without any liability.
This receiver is compatible with remote controllers which have ELRS 2.4G/915MHz hardware，not only compatible with our commando8.
ELRS RX and TX from different manufacturers can be used together, but different degrees of Oscillator (XO) Frequency Error may occur. Therefore We recommend using ELRS TX and Rx from the same manufacturer.
Use the preset in betaflight to recover the default setup.
1. Turn on the GPS rescue mode through the remote control. After the drone flies back, flip the switch to turn off the mode.
2. If the drone has automatically triggered the GPS rescue and you want to take over manually after flying back, you need to toggle any joystick on the left or right to take over, instead of flipping the GPS rescue switch.